Table of Contents
Advertisement
75LIV
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART 2 Mode This item allows you to select which mode for the
IR Function Duplex This item allows you to select the IR half / full
TX, RX inverting
enable
Onboard Parallel Port This item allows you to determine onboard parallel
Onboard Parallel Mode Select an operating mode for the on-board parallel
Select Enabled if your system has a floppy drive
controller (FDC) installing in the system board and
you want to use it. If you install add-in FDC or the
system has no floppy drive, select Disabled in this
field.
The choices: Enabled; Disabled.
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
Onboard Serial Port 2.
The choices: Standard; HPSIR; ASKIR
duplex function.
The choices: Half; Full.
This item allows you to enable the TX, RX inverting
which depends on different H/W requirement. This
field is not recommended to change its default
setting.
The choices: "No, No"; "No, Yes"; "Yes, No"; "Yes,
Yes".
port controller I/O address setting.
The choices: 378H/IRQ7; 278H/IRQ5; 3BC/IRQ7;
Disabled.
(printer) port. Select Normal, Compatible, or SPP
unless you are certain your hardware and software
both support one of the other available modes.
66
Advertisement
Table of Contents
