Jumper Setting For Devices On Board; Jumper Jbat1/2 For Clearing Cmos Data - SOLTEK SL-65MIE User Manual

2- 5 JUMPER SETTING FOR DEVICES ON BOARD:

• The following diagrams show the location for jumper blocks on the
mainboard.
CAUTION
• Do not remove the jumper when power is on. Always make sure the power
is off before changing any jumpers. Otherwise, mainboard could be damaged.
• All jumper pins with block marks are closed pins.

2-5-1 JUMPER JBAT1/2 FOR CLEARING CMOS DATA:

CPUFAN1
ATX POWER
JP7
JP8
1
1
RT1
COM2
Intel
815E
GMCH
SCR1
14
1
AGP 4X
AUXFA1
PCI 1
Intel
AC'97 CD32 1 4
Codec
PCI 2 ICH2
CD33 1 4
JWOL1
PCI 3
FWH
16
CNR 1 1
USB2
A battery should be used to supply the power for the CMOS RAM to retain mainboard
configuration.
You can clear CMOS by setting pin 2-3 closed when the system is POWER OFF. Then,
NOTE :
return to pin 1-2 closed position (default). You may damage the mainboard if clearing the CMOS
with POWER ON . Unplugging the power cord from power supply before clearing CMOS will
be the safest bet for user.
3
3
Clock
Generator
RT2
Li
Battery
CHAFA1
Chapter 2 Hardware Setup
Jumper JBAT1/2 for Clearing
CMOS Data
Clear CMOS Data
Retain Data (default)
21
3
3
1
1
3
3
1
1