Jumper Setting For Devices On Board; Jumper Jbat1 For Clearing Cmos Data - SOLTEK SL-75KIV User Manual

2-5 JUMPER SETTING FOR DEVICES ON BOARD:

• The following diagrams show the location for jumper blocks on the
mainboard.
CAUTION
• Do not remove the jumper when power is on. Always make sure the power
is off before changing any jumpers. Otherwise, mainboard could be
damaged.
• Pins with block mark are closed pins.

2-5-1 JUMPER JBAT1 FOR CLEARING CMOS DATA:

JUSB1
3 1
SOCKET A
RT2
VIA
VT8363A
AGP 4X
1 3
FAN2
PCI 1
PCI 1
AC'97
Codec
1 3 WOL1
PCI 2 PCI 2
PCI 3 PCI 3
USB2
JCOD1
CNR 1 1 3 1
A battery should be used to supply the power for the CMOS RAM to retain
mainboard configuration.
NOTE :
You can clear CMOS by setting pin 2-3 closed when the system is
POWER OFF. Then return to pin 1-2 closed position (default). You may damage
the mainboard if clearing the CMOS with POWER ON . Unplugging the power
cord from power supply before clearing CMOS will be the safest bet for user.
FAN1
SW1
1 3
Clock
Generator
Li
Battery
RT2
VIA
VT82C
686B
JP14
JP12
16 JP13
JP15
1 3 1 3
Chapter 2 Hardware Setup
Jumper JBAT1 For Clearing
CMOS Data
Clear CMOS Data
Retain Data (default)
25
JBAT1
1 3
JBAT1
1 3