Removing And Installing The Front Bezel (Pedestal Only); Removing The Front Bezel (Pedestal Only); Figure 21. Installing The Chassis Cover - Intel P4000IP Series Service Manual

Removing and Installing the Front Bezel (Pedestal
Only)

Removing the Front Bezel (Pedestal Only)

NOTE
For a rack configuration or chassis on its side, position the chassis hanging over the edge of a table or
workbench before removing the bezel.
There are two type of bezel assembly. One type is for fixed HDD configuration, the other type is for Hot-
swap HDD configuration.
CAUTION
Do not rotate the bezel assembly more than 40 degrees or you will damage the bezel assembly.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
3.
4. Release the two plastic tabs on the left side of the bezel assembly to disengage the tabs, and rotate
the bezel assembly (see letter "A") no more than 40 degrees outward.
At a 40-degree angle, push the bezel assembly away from the chassis (see letter "B").
5.
6. If the bezel assembly does not immediately disconnect from the chassis, tap the left-hand side of the
bezel assembly to disengage the bezel hooks on the right-hand side of the chassis.
®
Intel Server System P4000IP and Intel

Figure 21. Installing the Chassis Cover

®
Workstation System P4000CR Service Guide
Hardware Installations and Upgrades
23