Rear-Wheel Position - Vermeiren Inovys Series Installation Manual

Rear-wheel position

3.1
CAUTION
After adjustment of the rear wheels, check the working of the brakes and adjust according
to §3.5.
For each type of driving wheel (16", 22" and 24"), two adjustment positions are available:

Holes no. 1 for 24" driving wheels, with 45 mm in between;

Holes no. 2 for 22" driving wheels, with 45 mm in between;

Holes no. 3 in the frame tubes, for 16" driving wheel, with 50 mm in between;
The delivered wheel sockets fits in each of the four bores of the mounting plate.
The wheel sockets for the 16" wheels (transit version) only fit in the bores (3) of the
frame tubes.
To change the position of the wheel socket:
1. Remove the rear wheels, see user manual.
2. Remove the hex nut (4) on the inside of the mounting plate. Collect the wheel socket,
washer, distance ring (2x) and bushing.
3. Mount the wheel socket in the other bore, according to the part drawing of the
specific type of wheelchair assembly.
4. Tighten the hex nut (4) firmly.
5. Repeat this for the second wheel socket. Make sure that the wheel sockets, left and
right side, are mounted in the corresponding bore of the mounting plate.
6. Install both rear wheels.
Risk of injuries or damage
4
Installation manual
3
- 5 -
Inovys wheelchairs
2019-02
Adjustments
1
2
EN
NL
PL
CS