Table of Contents
Advertisement
Installation Information - Installation
Installing the logset
1.
Logset preparation
Remove logset and granule packet from packaging. To achieve the correct location of the
logset hold as shown below.
2.
Logset positioning into combustion chamber
Tilt the back of the logset upwards locating the front feet (1) behind the unpainted inner
horizontal lip (2). Ensure sides do not touch the combustion chamber walls.
Rotate the back of the logset down using the location of the front feet as pivot points.
3.
Logset correctly positioned
Logset will look like picture shown when installed correctly.
1
4.
Adding granules
Gently place granules in front of the main log. Level it with a pencil or screwdriver and remove
excess material. Do not pour granules as dust particles from plastic bag may block the burner
ports. If the logset is to be removed for any reason the granules must be removed first.
Any material that prevents the logs from sitting flat on the burner top can upset the burning
pattern and performance of the heater.
5.
Replace glass
Replace the glass ensuring the joint in the glass sealing tape is at the bottom.
Rinnai New Zealand
2
17
3
Compact Op/Install Manual: 10170-C 02-09
Advertisement
Table of Contents
