Installing The Mounting Plate; Installing The Light Kit - HAMPTON BAY 120-231 User Manual

9. Installing the Mounting
Plate
Step 1. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 19)
Mounting ring
Mounting plate
Figure 19
10. Installing the Light
Kit
REMEMBER: To disconnect the power.
The fan blades must be already attached to
the fan.
Step 1. L
mounting plate. (Do not remove)
Step 2. Raise and hold the light kit close to
the mounting
wire connections. Connect the white wire
connector from the light kit and fan, follow
the same procedure with the black wire
connectors. (Fig. 17)
Step 3. Place the key holes on the light kit
over the 3 screws previously loosened from the
mounting plate, turn light kit until it locks in
place at the narrow section of the key holes.
Secure by tightening the 3 screws previously
loosened.
Screws
oosen the 3 screws from the
and proceed to do the
plate
(Fig. 17).
Connector
plugs
Figure 20
Mounting plate
Light kit
Screws