Hanging The Fan 4 - HAMPTON BAY 120-231 User Manual

REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1. Remove two knock-outs from the
outlet box to expose the joist. (Fig. 5)
Step 2. Use the two wood screws and
washers to secure the hanger bracket plate
directly to the building joist via the
knockout holes from the outlet box. (Fig. 6)
CAUTION! THE HANGER BRACKET
P L A T E M U S T B E I N S TA L L E D
DIRECTLY TO THE BUILDING JOIST
USING THE TWO WOOD SCREWS AND
WASHERS PROVIDED.
Step 3. Secure hanger bracket to hanger
bracket plate using the two hex nuts and
washers provided, make sure nuts are
securely tighten. (Fig. 7)
Step 4. Loosen the two set screws and
remove the hitch pin and lock pin
coupling of the motor assembly. (Fig. 8)
Step 5. Remove hanger ball from downrod
assembly by loosening set screw, removing
the cross pin, and sliding ball off rod. (Fig.9)
Step 6. Carefully feed fan wires up through
the downrod. (Fig. 10) Thread the rod into
the coupling, next line up holes and replace
lock pin and hitch pin. Tighten set screws.
Step 7. Slip coupling cover, decorative scroll
ring, canopy cover and canopy onto downrod.
(Fig. 11) Carefully reinstall hanger ball onto
rod being sure that cross pin is in correct
position, set screws are tighten and wires are
not twisted.
Step 8. Now lift motor assembly into
position and place hanger ball into hanger
bracket. Rotate until the check groove has
dropped into the registration slot and seats
firmly. (Fig. 12) Rod should not rotate if this
is done correctly.
in the top
Knock out
Figure 5
Figure 7
Hanger
ball
Figure 9

Hanging the Fan 4.

Outlet box
Hanger
bracket
plate
Outlet box
Flat washers
Wood screws
Figure 6
Set
screws
Hitch
pin
Flat
washers
Spring
washers
Hex nuts
Figure 8
Cross pin
Downrod
Supply
wires
Downrod
Figure 10
Lock
pin