Standard Features; To Arm The System; Defective Zone Bypass & Alert; Auto Reset - Eaglemaster E5 Instruction Manual

STANDARD FEATURES:

-

To ARM the system:

To arm your system within proper operation range, simply press button
in disarmed or Acc off position) . The system will respond one siren chirp, one lights flash,
doors lock, disable engine starter, LED will begin flashing quickly until all sensor inputs are active
- LED will start blinking slowly (flash once per second) to indicate the system is in full armed.
2-way LCD display :
-
Defective Zone Bypass & Alert:
If the security system is armed at the same time that an input is active (such as a door opening
or hood / trunk opening ), you will hear one siren chirp to indicate arming and after 8 seconds
a second siren chirp to indicate Bypass Notification. A Bypass Notification chirp means that the
security system ignores the input that was active when the system was armed, until that input
ceases.
Defective zone
Door opened
Trunk opened
Hood opened
Note: You may press 2-way remote button
-

Auto Reset:

If a violation occurs the system will respond by sounding the siren and flashing the lights for
approximately 30sec. before the system resets itself and continues to protect your car. If violation
still occurs the system, siren and lights will working for 8 cycles then the system reset itself and
continues to protect other zones.

- Arm without siren chirp :

You may temporarily to arm your system without siren chirp , to operate it by simply press button
once then within 3sec. press button
The system will armed and without one siren chirp,
Note: this features is only activated under the system is in disarmed and Acc off position,.
Siren chirps 2-way beeps
3 chirps 1 long + 3 short
4 chirps 1 long + 4 short
5 chirps 1 long + 5 short
once to check again which zone is not closed.
once.
-13-
+ One beep sound
2-way LCD indicator
once (while system