Passive Immobilizer (Programmable); Arming Without Remote Control (Programmable); 2Nd Step Disarm - Eaglemaster E5 Instruction Manual

- Passive immobilizer (programmable):

If programmed with this function, when turn off ignition switch for 30 seconds or you open
and close the door, it will disable the engine starter right way . The LED will flash twice
per second.
2-way LCD display :
Exit: To disarm this function by (1) simply press button
Note: Under this mode, if ignition force been turn ON , siren will give 1long + 1 short chirps
warning, 10seconds later will activate the alarm, the 2way remote will indicate Anti
car-jack icon and warning sound. To disarm it with programmed "Valet SW or PIN
code " feature. (Please see Emergency disarm.)
- Arming without Remote control:
This function gives you a possibility to Arm and Disarm the system without remote control.
Note: if programmed with Passive arm feature, this feature will not activated.
- To activated arm without Remote control :
(1) After driving and ignition keep ON.
(2) Open a door, and keep it opened.
(3) Turn ignition OFF and within 10seconds. press Valet switch once.
(4) within 15 seconds, close door, the system will arm immediately.
- Disarm without Remote control:
Delay of alarm only available to activate while you have successfully enter into Arm W/O
RC mode ., within 20 seconds after opened the door or trunk switch. It allows you after
opening the door, to seat in to the car and enter 1st digit of PIN code. (10 seconds delay
time for Ignition turn on to set 1st PIN code). If within (10) seconds you didn't enter 1 digit
PIN code or insert wrong PIN code , the system will alarming., To re-set the system may
required only 2 digit PIN CODE (See "How to use your PIN code" ).
If programmed without PIN code, to disarm it by turn ignition on then press and hold the
Valet switch for over 5 seconds.
Note: To exclude unauthorized entering in to the car, pager output will activate immediately
after opening the door despite of the switched on delay of alarm mode.
- 2 step disarm:
This system offers 2 step disarm. It's a feature that make it possible to silence and reset
the system while it is triggering, without disarming the system. If the system is triggered
and the siren has been sounding, pressing any button once on the remote transmitter will
stop the trigger and return the unit to the armed state.
Note: Under system triggering, if press any button of 2-way remote once , the remote will
stop the beep sound and LCD display will indicate the intrusion icon for 2sec.
Press any button again to stop alarm triggering.
IMMO
IMMO
-18-
+ One beep sound
once. LED off.
st