Table of Contents
Advertisement
4 SYSTEM FUNCTIONS
6
Enter a mailbox number (up
to 20 digits) with the digital
keys and press the
[ENTER] button.
If you make a mistake, press one of the following keys to correct the mistake. For
key locations of [BACKSPACE], [DELETE] and [INSERT], see the following page.
[CLEAR/STOP] key:
Pressing this key clears all of the values that you entered.
[BACKSPACE] key:
Each press of this key deletes the values that you are entering one by one.
[DELETE] key:
Pressing this key after highlighting the value with the key deletes the value.
[INSERT] key:
Pressing this key permits the insertion of a desired character before (in front of) an
existing character highlighted by the cursor. Press this key again to exit the Insert
mode.
When 100 mailboxes have been
already registered, the screen on
the right appears for about 2
seconds and returns to the basic
screen.
When the mailbox specified has
been already registered:
Since the screen on the right
appears, select the desired item
using the
press the [ENTER] button.
[1. MODIFY]:
To modify the contents such as
relay end terminals currently
registered.
→ go to step 7.
[2. RETAIN]:
To not modify the contents such
as relay end terminals currently
registered.
→ go to step 6.
7
To set a password, select
"1. YES" using the
[ENTER] button.
When a password is not
required, select "2. NO".
→ go to step 9.
116
Mailbox Communication
P.29 "Keyboard"
or
button and
button and press the
MAILBOX SETUP(RELAY)
NEW MAILBOX NUMBER(MAX20):
500
MAILBOX SETUP(RELAY)
No more MAILBOX
MAILBOX SETUP(RELAY)
Already assigned
MAILBOX SETUP(RELAY)
1.MODIFY
2.RETAIN
MAILBOX SETUP(RELAY)
or
PROGRAM PASSWORD?
1.YES
2.NO
Advertisement
Table of Contents
