Advertisement
PPA-13X
STEP 4
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
Cable routing:
arm frame (D).
attached to left side of pulley plate (B).
around the pulley attached to pulley holder (F).
cable back up and over the pulley attached to right side of
pulley plate (B).
insert of right arm frame (C).
near the bottom of your PLA-144X and route it under and
around the pulley attached to pulley frame (E).
the end of the PLA-144X cable to the hook located on the
bottom of pulley holder (F).
(P1)
attach cable to round insert of left
(P2)
route cable over and down the pulley
(P5)
attach other end of cable to round
16
(P3)
(P6)
unhook the cable attached
route cable
(P4)
route
(P7)
attach
Advertisement
