Billion BiPAC 7800 User Manual page 71

AP Firmware Version: The Access Point firmware version.
WPS Service: Select Enable if you would like to activate WPS service.
WPS State: This column allows you to set the status of the device wireless setting whether it
has been configured or unconfigured. For WPS configuration please refer to the section on
Network Setup for detail.
WMM: This feature is used to control the prioritization of traffic according to 4 Access categories:
Voice, Video, Best Effort and Background. Default is set to disable.
Wireless Distribution System (WDS)
It is a wireless access point mode that enables wireless link and communication with other access
points. It is easy to install simply by defining the peer's MAC address of the connected AP. WDS
takes advantages of the cost saving and flexibility which no extra wireless client device is required to
bridge between two access points and extending an existing wired or wireless infrastructure network
to create a larger network. It can connect up to 4 wireless APs for extending cover range at the same
time.
In addition, WDS also enhances its link connection security mode. Key encryption and channel must
be the same for both access points.
WDS Service: The default setting is Disabled. Check Enable radio button to activate this
function.
1. Peer WDS MAC Address: It is the associated AP's MAC Address. It is important that your
peer's AP must include your MAC address in order to acknowledge and communicate with
each other.
2. Peer WDS MAC Address: It is the second associated AP's MAC Address.
3. Peer WDS MAC Address: It is the third associated AP's MAC Address.
4. Peer WDS MAC Address: It is the fourth associated AP's MAC Address.
Note: For MAC Address, the format can be: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx.
Click Apply to confirm the settings.
You can click Security settings link next to Cancel button to go to Wireless Security screen (see
Wireless Security section).
67
Wi-Fi