QoS - Quality of Service
QoS helps you to control the data upload traffic of each application from LAN (Ethernet and/
or Wireless) to WAN (Internet). It facilitates you the features to control the quality and speed of
throughput for each application when the system is running with full upstream load.
Application: Assign a name that identifies the new QoS application rule.
Direction: Shows the direction mode of the QoS application.
Protocol: Select the supported protocol from the drop down list.
DSCP Marking: Differentiated Services Code Point (DSCP), it is the first 6 bits in the ToS byte.
DSCP Marking allows users to classify the traffic of the application to be executed according to the
DSCP value.
Rate Type: You can choose Limited or Guaranteed.
Ratio: The rate percent in contrast to that on WAN interface.
Priority: The priority given to each policy/application. Its default setting is set to High. You may
adjust this setting to fit your policy / application.
Internal IP Address: The private IP in the LAN network.
External IP Address: The IP address on the Internet.
Internal Port: The Port number on the LAN side.
External Port: The Port number on the Remote/WAN side.
Time Schedule: A self defined time period. You may specify a time schedule for your QoS policy.
For setup and detail, refer to Time Schedule section.
Note: Make sure that the router(s) in the network backbone are capable to execute and check
the DSCP throughout the QoS network.