Port Mapping - Billion BiPAC 7800 User Manual

Port Mapping

Application: Select the service you wish to configure.
Protocol: A protocol is automatically applied when an Application is selected from the listbox or you
may select a protocol type which you want.
External Port & Internal Port: Enter the public port number & range you wish to configure.
Internal IP Address: Enter the IP address of a specific internal server to which requests from the
specified port is forwarded.
Add: Click to add a new virtual server rule. Click again and the next figure appears.
Edit: Check the Edit radio button to display the parameter of the selected application, then after
changing the parameters click the Edit/Delete button to apply the changes.
Delete: To remove a port mapping application, check the Remove box of the selected application
then click the Edit/Delete button.
Time Schedule: A self defined time period. You may specify a time schedule for your port mapping.
For setup and detail, refer to Time Schedule section.
Since NAT acts as a "natural" Internet firewall, your router protects your network from accessed
by outside users, as all incoming connection attempts point to your router unless you specifically
create Virtual Server entries to forward those ports to a PC on your network. When your router
needs to allow outside users to access internal servers, e.g. a web server, FTP server, Email server
or game server, the router can act as a "virtual server". You can set up a local server with a specific
port number for the service to use, e.g. web/HTTP (port 80), FTP (port 21), Telnet (port 23), SMTP
(port 25), or POP3 (port 110). When an incoming access request the router for a specified port is
received, it is forwarded to the corresponding internal server.
For example, if you set the port number 80 (Web/HTTP) to be mapped to the IP Address 192.168.1.2,
then all incoming HTTP requests from outside users are forwarded to the local server (PC) with the
IP address of 192.168.1.2. If the port is not listed as a predefined application, you need to add it
manually.
In addition to specifying the port number used, you also need to specify the protocol used. The
protocol is determined by a particular application. Most applications use TCP or UDP, however you
may also specify other protocols using the drop-down Protocol menu. Setting the protocol to "all"
causes all incoming connection attempts using all protocols on all port numbers to be forwarded to
120