Removing And Replacing The Keypad - Motorola MOTOSLVR L9 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Keypad

6809510A66-O
1. Remove the battery cover, battery, SIM, rear housing, and transceiver PC
board, as described in the procedures.
2. Lift the keypad up from one corner as shown in Figure 15 and remove it from
the front housing.
Figure 15. Removing and Replacing the Keypad
3. To replace, align the keypad holes with the front housing pins and place the
keypad onto the front housing.
4. Reassemble the front housing, transceiver PC board, transceiver PC board
shield, antenna cap, SIM, battery and battery cover as described in the
procedures.
October 12, 2006
Keypad
Alignment pin
Disassembly
Front housing
061543o
29