Removing And Replacing The Lower Pcb And Keypad - Motorola MPx220 Service Manual

Disassembly

Removing and Replacing the Lower PCB and Keypad

30
1. Remove the battery door, battery, front housing cover, upper PCB, receiver, camera-
module FPC connector, flush-light FPC connector, rear housing cover, carrier antenna,
vibrator connector, daughter board, and vibrator as described in the procedures.
2. Lift the lower PCB up from the rear housing by releasing the housing latches on each side
of the rear housing and pushing the keypad below the lower PCB upward as shown in
Figure 23.
Housing Latches
Figure 23. Partially Removing the Lower PCB
3. Remove the keypad below the lower PCB from the phone as shown in Figure 24.
Figure 24. Removing the Keypad
December 22, 2004
MPx220