Removing And Replacing The Antenna - Motorola MOTOSLVR L9 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Antenna

6809510A66-O
6. Remove the flex from the chassis.
7. Left the keypad PC board away from the phone.
8. To replace, align the flex connector the keypad PC board and gently press the
connector until properly seated in the connector socket.
9. Thread the coaxial cable around the cable guide and seat the connector onto
its socket on the keypad PC board.
10. Insert and tighten the 2 T3 screws.
11. Paste on the silver chassis seal.
12. Reassemble the front housing, transceiver PC board, transceiver PC board
shield, antenna cap, SIM, battery and battery cover as described in the
procedures.
1. Remove the battery cover, battery and SIM, as described in the procedures.
2. Use the plastic tweezers to lift the antenna assembly out of the phone (see
Figure 18).
Figure 18. Removing and Replacing the Antenna
3. Carefully remove the antenna from the phone.
4. To replace, insert the antenna into the antenna slot on the phone. Ensure the
antenna makes contact with the RF contacts on the PC board.
5. Reassemble the keypad PC board, keypad, front housing, transceiver PC board,
transceiver PC board shield, antenna cap, SIM, battery and battery cover as
described in the procedures.
October 12, 2006
Antenna assembly
Disassembly tool
Disassembly
061618o
31