KTI Networks KVB-311 User Manual page 93

usr/config$
Parameter Usages:
-print: Print current call progress tone configurations (ring: ring tone, rbt: ring back
tone, bt: busy tone, dt: dial tone). This parameter should be accompanied with
tone type.
-ring: To set RING tone value. The played tone type, when Gateway is receiving a
call.
-rbt: To set RingBackTone value. The played tone type, when Gateway receives a
Q.931 Alerting message. In condition that Gateway is the originate side.
-bt: To set BusyTone value. The played tone type, when destination is busy.
-dt: To set DialTone value. The played tone type, when hook off a phone set of
workable Gateway.
-flash: Set the detective flash range in ms, for example, 300-500 ms.
Note:
For tone simulation, Gateway adopts dual frequencies as traditional telephone does. If
users want to have their own call progress tone, they can change the value of tones.
High and Low frequency/level/cadence can be configured respectively.
For example:
usr/config$ phone -print rbt
Phone ringback tone paramter
Ringback Tone frequency high
Ringback Tone frequency low
Ringback Tone frequency high level : 155
Ringback Tone frequency low level
Ringback Tone tone1 on
Ringback Tone tone1 off
Ringback Tone tone2 on
Ringback Tone tone2 off
usr/config$
usr/config$ phone -print rbt
Phone ring back tone paramter
Ringback Tone frequency high
KVB-311 Broadband VoIP Router User Manual
: 480
: 440
: 155
: 2000
: 4000
: 2000
: 4000
: 440
- 88 -