Resetting To Factory Defaults - FLIR DNB13TL2 Instruction Manual

7. RESETTING TO FACTORY DEFAULTS

Follow the steps below to revert all settings to factory defaults. The camera
must be connected to power to perform a factory reset.
1. Open the service
compartment near the
camera base by loosening
the screws (2x) with the
included allen key.
2. Press and hold the black
reset button for 5 seconds
then release the button to
reset the camera to factory
defaults.
3. Close the service
compartment and firmly
tighten the screws (2x)
Resetting to Factory Defaults
1
2
Reset button
59