Advertisement
PGM200X
STEP 1
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
1A. insert a oval end cap into the front opening of
mainframe (A) and side openings of base frame (B) using:
3 - (#1) 40X80mm oval end cap
1B. attach base frame (B) to mainframe (A) using:
2 - (#30) M10X55mm hex head bolt
4 - (#50) M10 washer
2 - (#40) M10 nylon lock nut
1C. attach r-elbow frame (C) and l-elbow frame (D) to
mainframe (A) using:
2 - (#31) M10X60mm hex head bolt
4 - (#50) M10 washer
2 - (#40) M10 nylon lock nut
note: adjust hole position as necessary to accomodate
your personal body height.
1D. attach a elbow pad (N) to r-elbow frame (C) and
l-elbow frame (D) using a total of:
4 - (#33) M8X20mm hex head bolt
4 - (#54) M10 spring washer
4 - (#51) M8 washer
10
Hide quick links:
Advertisement
