Step 4 - Turning On Your Monitor; Step 5 - Testing And Getting To Know Your Monitor; Turning On; Testing Sensor Pad - Angelcare AC601 Owner's Manual

STEP 4 - TURNING ON YOUR MONITOR

1
2
3
4
Power Indicator on both units will
light up when monitor is turned on.
DETECTION MODE FEATURES
1
14
1) Slide ON Parent Unit Volume/Power
button.
2) Push Nursery Unit Power ON/OFF
button for 2 seconds.
3) Set both Units on the same channel
(A, B or C). Must always be on
matching channels.
4) Select your detection mode .
Sound and Movement
Allows you to detect baby's sounds and
movements as well as hear a TIC sound
at each movement.
Tic OFF
Allows you to detect the baby's sounds
and movements without the TIC sound.
Sound Only
Allows you to detect ONLY the baby's
sounds. Movement detection will
be deactivated.
1) Movement Indicator
Light activated by your
baby's movement.
2
2) Sound Lights
Sound lights on the Parent
Unit are activated by the
sounds of your baby. As the
sounds get louder, more
lights will illuminate.

STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR

5.1 - SENSOR PAD
TO TEST THE SENSOR PAD:
1 2
MOTION ALARM
• If NO movement is detected after 15 seconds you will hear a single 'TIC' pre-alarm
sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement detected both the Parent Unit
and Nursery Unit speakers will emit a loud warning sound.
• Green light on the Nursery Unit will turn off to indicate
NO movement is being detected.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust the Sensor Pad sensitivity level.
TO STOP THE ALARM
Place your hand OR
back on the
mattress.
1) Move your hand lightly on the mattress.
The Nursery Unit Movement
Indicator will flash continuously.
2) Remove your hand from the mattress.
After 15 seconds you will hear a 'TIC'
pre-alarm sound, and 5 seconds later
the Movement Alarm will trigger.
3) Repeat by moving your hand lightly in
all four corners of the mattress. Ensure
the Nursery Unit Movement Indicator is
still flashing.
Shut the Nursery
Unit OFF
15