Angelcare AC601 Owner's Manual
Angelcare AC601 Owner's Manual

Angelcare AC601 Owner's Manual

Simplicity movement sensor with sound baby monitor
Hide thumbs Also See for AC601:

Advertisement

OWNER'S MANUAL
SIMPLICITY MOVEMENT SENSOR
WITH SOUND BABY MONITOR
Model AC601
IMPORTANT ADVICE FOR INITIAL SETUP
Movement Alarm
Your monitor comes with the movement alarm activated.
When switching on your monitor it will alarm, with or without
the Sensor Pad plugged in, if no movement is detected.
Deactivate the movement function to use the monitor without
the Sensor Pad.
Channel Selection
When monitoring sound and/or movement, the channel options
on both Parent and Nursery Unit must be set to the same
position: A, B or C. This can be done by sliding the switches on
the left side of both units to the markings indicating A, B or C.
Cord Safety
Ensure the Nursery Unit is at least 1 metre away from your
baby's cot. The Sensor Pad cord must always be kept out of
reach of baby and secured using the cord cover kit provided.
Voice-activated Sound Transmission
Your monitor will transmit when it detects sound from
your baby or in their room. You can adjust the microphone
sensitivity to suit your needs.
PLEASE FOLLOW THE INSTRUCTIONS CAREFULLY FOR CORRECT SETUP
Please DO NOT return this product to the store. For assistance please
contact our helpline on 0345 009 1789 or email helpline@babyhelpline.co.uk
Mon – Fri 10am – 4pm, excluding bank holidays.
for your peace of mind

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC601 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Angelcare AC601

  • Page 1 OWNER’S MANUAL SIMPLICITY MOVEMENT SENSOR WITH SOUND BABY MONITOR Model AC601 IMPORTANT ADVICE FOR INITIAL SETUP Movement Alarm Your monitor comes with the movement alarm activated. When switching on your monitor it will alarm, with or without the Sensor Pad plugged in, if no movement is detected.
  • Page 2: Table Of Contents

    Keep small parts away from children when assembling. This Angelcare Monitor is a Personal Care Product. Please DO NOT return this to the store where you purchased it from. If you have any questions or require assistance please call the Angelcare Helpline on 0345 009 1789 or email helpline@babyhelpline.co.uk.
  • Page 3: Warnings

    WARNINGS 1. THIS PRODUCT CANNOT REPL ACE CAUTION RESPONSIBLE ADULT SUPERVISION. This product is designed to aid in the monitoring RISK OF ELECTRIC SHOCK of your child. When using the monitor, you DO NOT OPEN must still provide the supervision necessary DO NOT EXPOSE TO RAIN OR MOISTURE for the continued safety of your child.
  • Page 4 15. IMPORTANT SAFETY INSTRUCTIONS 15.10 Accessories - Only use attachments/ accessories specified by the manufacturer. DO NOT place this product on an unstable 15.1 Read these instructions - All the safety cart, stand, tripod, bracket or table. The instructions should be read before the product may fall, causing serious injury product is operated.
  • Page 5 Sensor Pad measuring at this product that are not intended to be least 33 x 33 cm and 6 mm thick. Only use charged. The batteries may leak corrosive your Angelcare monitor in a stationary ® electrolyte or explode.
  • Page 6 16.10 DO NOT attempt to rejuvenate the 17.2 NOTE: This equipment has been tested batteries provided with or identified for and found to comply with Part 15 of the use with this product by heating them. FCC Rules and the Industry Canada licence- Sudden release of battery electrolyte may exempt RSS standard.
  • Page 7: Ac601 Setup Requirements

    MOVEMENT SENSOR SETUP REQUIREMENTS WITH SOUND MONITOR Model AC601 INCLUDED: 1 Sensor Pad (AC601) with pre-installed cord covers Parent Unit Nursery Unit 2 AC Adapters 3 Rechargeable AAA Batteries for Parent Unit WHAT YOU WILL NEED (NOT INCLUDED): YOU MUST PREPARE:...
  • Page 8: Step 1 - Charging The Parent Unit (15 Hours)

    STEP 1 - CHARGING THE PARENT UNIT (15 HOURS) IMPORTANT Never use regular alkaline batteries in the Parent Unit; they may explode. 1) Remove the battery cover and insert the Rechargeable Batteries (included). 2) Connect the AC Adapter to the Parent Unit and into an electrical outlet.
  • Page 9 NURSERY UNIT BATTERY ALARM • Low Battery Indicator flashes when batteries need to be changed. • If the batteries are not replaced, the monitor will stop working. HOW TO CHARGE THE BATTERIES IN THE PARENT UNIT: Plug the AC into the Parent Unit and a working electrical outlet.
  • Page 10: Step 2 - Installing The Sensor Pad

    STEP 2 - INSTALLING THE SENSOR PAD Cord covers 1, 2, 3, 4: Position on floor Cord cover 4: Contains double sided tape to securely install beneath crib leg Cord cover 5: Position vertically between mattress support and floor Sensor Pad with pre-installed cord covers Cord cover 6: Place under the mattress...
  • Page 11 2.2 - SELECT THE CRIB LEG YOU WILL BE USING TO SECURE THE CORD COVERS RECOMMENDED Use the crib leg by the wall closest to the Nursery Unit (Fig 1). In cases where the Nursery Unit is across the room, use the leg closest to the Nursery Unit to position the covered wire (Fig 2).
  • Page 12 8 cm 6) Place the 6 cord cover approximately 8 cm from the edge of the mattress support. 7) Snap together the remaining cord covers that will run along the floor. 8) Remove any cord slack to make sure CLIC! no parts of the cord are loose.
  • Page 13: Step 3 - Setting Up The Nursery Unit

    STEP 3 - SETTING UP THE NURSERY UNIT 1) Remove the battery cover and insert 4 AAA Alkaline Batteries ( not included). 2) Place the Nursery Unit at a minimum of 1 m away from the crib. 3) Connect the AC Adapter to the Nursery Unit and plug into an electrical outlet.
  • Page 14: Step 4 - Turning On Your Monitor

    STEP 4 - TURNING ON YOUR MONITOR 1) Slide ON Parent Unit Volume/Power button. 2) Push Nursery Unit Power ON/OFF button for 2 seconds. 3) Set both Units on the same channel (A, B or C). Must always be on matching channels.
  • Page 15: Step 5 - Testing And Getting To Know Your Monitor

    STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR 5.1 - SENSOR PAD TO TEST THE SENSOR PAD: 1) Move your hand lightly on the mattress. The Nursery Unit Movement Indicator will flash continuously. 2) Remove your hand from the mattress. After 15 seconds you will hear a ‘TIC’...
  • Page 16 TO ADJUST THE SENSOR PAD SENSITIVITY LEVEL: Turn the Nursery Unit sensitivity dial from less sensitive (0) to very sensitive (5). NOTE: If you are experiencing false alarms, adjust the sensitivity level. For better result, start by half level increases or decreases. IMPORTANT • The Sensor Pad is not designed for use with adults, children or infants older than 24 months.
  • Page 17 OUT-OF-RANGE ALARM • Alarm activates when your two units are not communicating. • The Parent Unit will emit a double beep every 8 seconds. IMPORTANT If the Out-of-Range function is activated and you turn the Nursery Unit OFF the Out-of-Range Alarm will sound. Turn the Nursery Unit ON again to reconnect both units.
  • Page 18: Troubleshooting

    TROUBLESHOOTING TAKING CARE OF YOUR RECHARGEABLE BATTERIES • Ensure that you fully charge your batteries for 15 hours before their first use. • To maintain maximum battery life it is recommended that you fully discharge your batteries periodically. Battery performance can be diminished by leaving the batteries constantly charging.
  • Page 19: Limited Warranty

    ® rechargeable, movement and sound monitor (model AC601) is free from any material and workmanship defects, for a period of one (1) year (rechargeable batteries not included) from the date of the original purchase. If this monitoring system fails to function properly when used as...
  • Page 20: Technical Specifications

    Asia/Africa and on the 927 MHz frequency for North America/Ecuador/Oceania. Caution: To reduce the risk of electric shock, do not expose this product to rain Hereby, Angelcare Monitors Inc, declares or moisture. this baby monitor is in compliance with the essential requirements and other relevant Danger of explosion if batteries are provisions of Directive 1999/5/EC.
  • Page 24 This Angelcare Baby Monitor is a Personal Care Product. Please DO NOT return this to the store, but contact us initially for advice and assistance: Angelcare Helpline on 0345 009 1789 Website: www.angelcare.co.uk Email: helpline@babyhelpline.co.uk NOTE: Helpline is open Monday to Friday, 10am to 4pm, excluding bank holidays.

Table of Contents