Sj Board - Toshiba QOSMIO F10 Maintenance Manual

4 Replacement Procedures
4.21

SJ board

Removing the SJ board
The following describes the procedure for removing the SJ board (See Figure 4-37).
1. Disconnect the microphone cable from the connector CN6000 on the SJ board.
2. Unlock the connector CN9560 on the SJ board and disconnect the SJ board flat
cable from it.
3. Remove the following screw fixing the SJ board and remove the SJ board.
?
4. Remove the glass tape and pull out the SJ board flat cable from the slit of the
middle frame.
M2x4Z BIND
Microphone cable
QOSMIO F10 Maintenance Manual (960-498)
M2? 4Z BIND screw
SJ board
CN6000
Figure 4-37 Removing the SJ board
x1
Glass tape
CN9560
Insulator
4.21 SJ board
Slit
SJ board flat cable
Guide lines
4-55