Toshiba QOSMIO F10 Maintenance Manual page 248

4.4 Memory module
Installing the memory module
To install the memory module, confirm that the computer is in boot mode. Then perform the
following procedure (See Figure 4-6).
1. Insert the memory module into the connector of the computer slantwise (terminal
side first) and press it to connect firmly.
CAUTION: The power must be turned off when you insert the memory module. Inserting
a memory module with the power on might damage the module or the
computer itself.
Never press hard or bend the memory module.
When installing a memory module, always install it to Slot A first.
2. Install the memory slot cover and secure it with the screw.
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, check that it is connected correctly.
4-16
4 Replacement Procedures
QOSMIO F10 Maintenance Manual (960-498)