Sound Troubleshooting - Toshiba QOSMIO F10 Maintenance Manual

2 Troubleshooting Procedures

2.14 Sound Troubleshooting

To check if the sound function is defective or not, follow the troubleshooting procedures
below as instructed.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
Execute the Sound Test in the Diagnostic Program. Refer to Chapter 3, Tests and Diagnostics
for more information on how to perform the test program.
If any error is detected by the test, go to Procedure 2.
Procedure 2 Connector Check
The connection of sound system is shown in the following figure.
As the connection may be bad, disassemble the PC and check each connection.
If each component and board is firmly connected but the sound function does not work
properly, go to Procedure 3.
QOSMIO F10 Maintenance Manual (960-498)
2.14 Sound Troubleshooting
2-57