Table of Contents
Advertisement
Movement Speed
Fan Operation
Display ON/OFF
Intimidator™ Wash Zoom 350 IRC User Manual Rev. 1
The movement, or pan and tilt speed, can be adjusted and will affect the speed of the Auto
and Sound modes.
To set the pan and tilt speed, do the following:
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Setup icon.
3. Press <ENTER>. The Setup options will show on the display.
4. Use <UP> or <DOWN> to highlight the P/T Speed option.
5. Press <ENTER> and Normal, Fast, or Slow will show in green.
6. Use <UP> or <DOWN> to select the desired speed.
7. Press <ENTER> to select the setting.
The fans in the unit can be set to Full to remain on or set to Auto to run only when the
product is hot enough to need a fan.
To set the fans to Full or Auto, do the following:
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Setup icon.
3. Press <ENTER>. The Setup options will show on the display.
4. Use <UP> or <DOWN> to highlight the Fans option.
5. Press <ENTER>. The words Full or Auto will show in green.
6. Use <UP> or <DOWN> to switch between Full and Auto.
7. Press <ENTER> to select the setting.
The display can be set to stay on permanently (ON), or to go off (OFF) when the menu is
not being used.
If the display is set to ON, it will remain in any given menu for 30 seconds of inactivity, and
then it will return to a home screen that shows the product's current mode and DMX
address.
If the display is set to OFF, it will remain in any given menu for 30 seconds of inactivity, and
then it will go blank and show nothing.
To set the display ON or OFF, do the following:
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Setup icon.
3. Press <ENTER>. The Setup options will show on the display.
4. Use <UP> or <DOWN> to highlight the Display option.
5. Press <ENTER>. The words ON or OFF will show in green.
6. Use <UP> or <DOWN> to switch between ON and OFF.
7. Press <ENTER> to select the setting.
If the display is set to OFF, it will come back on when the IRC-6 is used or when any
menu button is pressed; however, it will not come on when it receives DMX control.
Page 25 of 31
Advertisement
Table of Contents
