Ir Mode; Irc-6 Operation - Chauvet Intimidator Wash Zoom 350 IRC User Manual

IR Mode

IRC-6 Operation

Intimidator™ Wash Zoom 350 IRC User Manual Rev. 1
IR mode allows the product to be controlled with an infrared remote controller. The IRC-6
can remotely set the product to various modes; adjust the color, speed and sensitivity; and
set the strobe.
To set the product to IR mode, do the following:
Make sure the product is plugged into a power source and not connected to a DMX cable.
1. Press <MENU> repeatedly until 4 icons show on the display.
2. Use <UP> or <DOWN> to highlight the Run Mode icon.
3. Press <ENTER>. The Run Mode options will show on the display.
4. Use <UP> or <DOWN> to highlight the IR option.
5. Press <ENTER>. A green dot will show on the IR option line and the product will begin
moving and emitting light.
The IRC-6 infrared controller (available from CHAUVET®) allows remote control of the
Intimidator Wash Zoom 350 IRC.
Be sure the IRC-6 remote is pointing directly at the product and there is nothing in
between the remote and the product.
Some of the buttons on the remote work differently than what is indicated on their
labels. For example:
· <MANUAL> controls the white color in the LEDs.
· <A>, <UV>, and <W> control the Blackout function.
Please read the next section carefully.
The list below describes which features each button controls.
· <BLACKOUT> - Turns LEDs on and off.
· <AUTO> - Activates Auto mode. Use the <+> and <-> buttons to cycle through Auto
modes.
· <SOUND> - Activates Sound mode.
· <STROBE> - Activates the strobe. Use the <+> and <-> buttons to cycle through strobe
speeds.
· <SPEED> - Adjusts the movement speed. Use the <+> and <-> buttons to cycle through
movement speeds.
· <SENSITIVITY> - Adjusts sound sensitivity. Use the <+> and <-> buttons to cycle
through sound sensitivity levels.
· <%> - Adjusts the brightness of the LEDs. Use the <+> and <-> buttons to increase or
decrease the brightness of the LEDs.
· <MANUAL> - Adjusts the white color in the LEDs. Use the <+> and <-> buttons to
increase or decrease the white color in the LEDs.
· <FADE/SNAP> or <FADE> - Adjusts the speed and type of color fades. Press the button
to switch between fade and snap color changes. Use <+> and <-> to increase or
decrease the speed of the color changes.
· <R> - Adjusts the red color in the LEDs. Use the <+> and <-> buttons to increase or
decrease the red color in the LEDs.
· <G> - Adjusts the green color in the LEDs. Use the <+> and <-> buttons to increase or
decrease the green color in the LEDs.
· <B> - Adjusts the blue color in the LEDs. Use the <+> and <-> buttons to increase or
decrease the blue color in the LEDs.
· <+> - Increases values for controls as described above.
· <-> - Decreases values for controls as described above.
· <0>–<9> - Activates specific Auto modes. Can be used as a shortcut for the combination
of the <AUTO> button and the <+> and <-> buttons.
Page 22 of 31