Operator Call Status Errors; Detection Errors; Service Call Status Errors - Printronix L5535 Maintenance Manual

Appendix C

Detection Errors

Detection Errors
The errors detected by these sensors and switches are as follows:

Operator Call Status Errors

Error
Stacker Error
Interlock action
Folding defective
Stacker full
Stacker not ready
Not auto mode
Stacker lowest position

Service Call Status Errors

Error
Stacker capacity over
Motor abnormality detection 1
Motor abnormality detection 2
Motor abnormality detection 3
Motor abnormality detection 4
II–288
Code
53 Check the connector between the stacker
and the printer.
54 Safety sensor 1 or 2 turned off, and
interlock operated.
55 Defective folding of paper occurred (PPS
on or off time counted up).
56 The volume of folded paper has reached
capacity (SFS detected elevator table).
57 Power stacker not ready.
58 Power stacker not in auto mode.
5C Elevator table in down position (EDS
detected elevator table).
Code
59 Elevator table is at highest or lowest
position (LIMT1 or LIMT2 detected
elevator table).
5A Action abnormality of stacker motor has
been detected.
5A Action abnormality of elevator motor has
been detected.
5A Action abnormality of swinger motor has
been detected.
5A Action abnormality of assisting arm drive
motor has been detected.
Meaning
Meaning