Zapi AC-2 User Manual page 40

5) CUTBACK SPEED
Speed reduction when the cutback switch is active.
6) 1ST SPEED FINE
First speed, fine regulation.
7) 2ND SPEED FINE
Second speed, fine regulation.
8) 3RD SPEED FINE
Third speed, fine regulation.
9) 4TH SPEED FINE
Fourth speed, fine regulation.
10) HYD SPEED FINE
Hydro speed, fine regulation.
11) MAXIMUM CURRENT
The maximum current of the inverter.
12) AUXILIARY TIME
Time delay when an hydraulic steering function request is switched off.
The following table shows the different values at which the parameters can be
set.
PARAMETER
ACCELER. DELAY (*)
DECELER. DELAY (**)
MAX SPEED UP
MIN SPEED UP
CUTBACK SPEED
SPEED FINE (ALL) (***)
MAXIMUM CURRENT
AUXILIARY TIME
(*)
(**)
(***)
After changing a parameter, press ENTER to confirm data when requested by
the message on the console. Parameters modified and optimized on one unit can
be stored by the console (SAVE) and then released (RESTORE) on another
inverter, thus allowing fast and standardized settings (see console manual for
details).
Page - 40/64
UNIT
0
Sec. 0.5
Sec. 0.5
Hz 65
Hz 0
%Max Sp 10
Hz -
%IMAX 47
Sec. 0
The acceleration time shown is the time from 0 Hz to 100 Hz (maximum
selectable speed). This is the ideal ramp calculated by the software; the
real ramp could change as a function of motor control parameter setting
and, obviously, as a function of the load.
The deceleration time shown in the table is the time from 100 Hz to 0
Hz. This is the ideal ramp calculated by the software; the real ramp
could change as a function of motor control parameter setting and,
obviously, as a function of the load.
Adjustable with a 1 Hz resolution in the 0 to 200 Hz range.
PROGRAMMED LEVEL
1 2 3 4
0.7 1.0 1.4 1.9
0.7 1.0 1.4 1.9
80 95 110 125
13.5 15.0 16.5 18.0 19.5 21.0 22.5 24.0
20 30 40 50
- - - -
53 58 64 70
0.2 0.4 0.8 1.0
ADEZP0AE - AC-2 INVERTER - User Manual
5 6 7 8
2.5 3.2 4.0 4.8
2.5 3.2 4.0 4.8
140 155 170 185
60 70 80 90
- - - -
76 82 88 94
1.5 2.0 3.0 4.0
9
5.5
5.5
200
25.5
100
-
100
5.0