Specifications - Samlexpower G4-2012A Owner's Manual

SECTION 10 |
Product Highlights
Power
Model no. rating*
G4-2012A 2000 vA
G4-2524A 2500 vA
G4-3524A 3500 vA
* Power rating is shown as Apparent Power in volt Amp (vA). Active Power in Watts will be controlled by the Power Factor of the AC side load i.e.
Active Power in Watts = Apparent Power in vA x Power Factor (normally ranges from 0.5 to 1). For resistive type of loads with Power Factor of 0.9
to 1, the Apparent Power in vA will be almost equal to the Active Power in Watts.
Utility / Generator Pass Through (bypass) Mode - external AC Line Input Is Available
Parameter
Input voltage Waveform
Input voltage range
Input voltage: Low Line Disconnect
Input voltage: Low Line Re-connect
Input voltage: High Line Disconnect
Input voltage: High Line Re-
connect
Nominal Input Frequency
Low Frequency Disconnect
Low Frequency Re-connect
High Frequency Disconnect
High Frequency Re-connect
Maximum AC Input Current
Output voltage Waveform
Output Overload and Short Circuit
Protections
Efficiency (Pass Through / Bypass
Condition)
Transfer Relay Rating
Transfer Time (Utility / Generator
to Inverter )
Minimum DC Input voltage
for Pass Through (Bypass) and
Charging
Maximum Pass Through (Bypass)
Overload Current
66 | SAMLEX AMERICA INC.

Specifications

input Connections
• Terminal Block, 65A for AC input
• M8 stud and nut for DC input
• M8 thumb nut for external
charger input
g4-2012a
10v higher than programmed value of Low Line Disconnect
5 v lower than the programmed value of High Line Disconnect
40A, limited by Circuit Breaker
marked "Charger"
40A Circuit Breaker marked
"Charger"
• 80A, 277 vAC (Two 40A relays in parallel) for the Line side (120v version)
• 80A, 277 vAC (Two 40A relays in parallel) for Neutral side for Neutral to Chassis Ground switching
9v
40A for G4-2012A
Circuit Breaker
"Charger"
40A
40A
60A
g4-2524a
Pure Sine Wave
120 vAC nominal (80 vAC to 140 vAC ± 4%)
Programmable: 80 vAC to 95 vAC ± 4%
Programmable:130 vAC to 140 vAC ± 4%
50Hz / 60Hz ( Auto detection )
Default: 60Hz for 120v version
57 ± 0.3Hz for 60Hz / 47 ± 0.3Hz for 50Hz
58 ± 0.3Hz for 60Hz / 48 ± 0.3Hz for 50Hz
65 ± 0.3Hz for 60Hz / 55 ± 0.3Hz for 50Hz
64 ± 0.3Hz for 60Hz / 54 ± 0.3Hz for 50Hz
40A, limited by Circuit Breaker
marked "Charger"
Same as waveform of Line input voltage
40A Circuit Breaker marked
"Charger"
> 95% (When battery is fully charged)
20 ms (Typical)
18v
40A for G4-2524A
Circuit Breaker Output Connections
"load"
30A Terminal Block, 65A
for AC output
35A
40A
g4-3524a
60A, limited by Circuit Breaker
marked "Charger"
60A Circuit Breaker marked
"Charger"
18v
60A for G4-3524A