Internal Fuse Rating & Specifications - Samlexpower SeC-1215UL Owner's Manual

seCtIOn 7 |
Both the AC side and DC sides have fuses that are located inside the charger. Disconnect
the AC power when checking or changing the fuses. Open the charger as follows:
1. Remove the 4 screws on the ammeter side of the top cover
2. gently slide the top cover out by about 2 to 3 inches.
(cAUtion! the top cover will be restrained from fully sliding out by the wires
connecting the ammeter , leD and fan)
3. The fuses will now be accessible
Fuse Ratings Table
FUSe RAtingS
120 VAC INPUT
DC OUTPUT
230 VAC INPUT
DC OUTPUT
Specifications Table
SPeciFicAtionS
Nominal Input Voltage (pre-set)
Internal Jumper Change
Input Frequency
Output Voltage, Boost
Output Voltage, Float
Output Amps
Operating Temperature Range
Weight
Housing Dimensions
(L x W x H) Inches / Millimetres
Protections
Output Banks
Safety Compliance
EMI Compliance
1. Voltages based on battery temperature of 80° F
2. Based on selection by DIP SWITCH. See pages 8 & 9
Specifications are subject to change without notice.
Internal Fuse ratings & specifications
Sec-1215Ul
4A / 125V
20A / 32V
2A / 250V
20A / 32V
Sec-1215Ul
120 VAC, 60 Hz,
3.3A
230 VAC, 50 Hz
50 - 60 Hz
14 VDC, or 14.4
1,2
VDC or disabled
13.5 VDC
1
15A
0 - 40°C
2.2 kg. / 4.8 lbs.
8.5 x 8.4 x 3.3 /
218 x 214 x 83
Short Circuit
Overload
3
i) Conforms to ANSI/UL STD 1564
ii) Certified to CAN/CSA STD C22.2 No. 107.2
FCC Part 15(B), Class B
Sec-1230Ul Sec-2415Ul
8A / 125V 8 A / 125V
2 x 20A / 32V 2 x 10A / 32V
4A / 250V 4A / 250V
2 x 20A / 32V 2 x 10A/32V
Sec-1230Ul Sec-2415Ul
120 VAC, 60 Hz, 120 VAC, 60 Hz,
6.5A 6.5A
230 VAC, 50 Hz 230 VAC, 50 Hz
50 - 60 Hz 50 - 60 Hz
14 VDC, or 14.4 28 VDC, or 28.8
VDC or disabled VDC or disabled
13.5 VDC 27.0 VDC
30A 15A
0 - 40°C 0 - 40°C
2.9 kg. / 6.4 lbs. 2.9 kg. / 6.4 lbs.
10.8 x 8.4 x 3.3 / 10.8 x 8.4 x 3.3 /
280 x 214 x 83 280 x 214 x 83
Short Circuit Short Circuit
Overload / Over Overload / Over
Temperature Temperature
3 3
SAMLEX AMERICA INC. | 17
4004711