Connecting Micron/A10 To A Pc Via The Firewire(Ieee-1394) Module - FLIR ThermoVision Micron User Manual

ThermoVision® Micron/A10 User's Guide 412-0006-10 Version 130
7. If you see the window shown in Figure 14, verify that the Ethernet Module LED is
powered on and connected to the PC. Then select the Ethernet Comm interface option
and then hit the "Connect" button. If the Control Panel successfully links to the camera,
skip ahead the section below titled "Operation of the Micron/A10 Control Panel".
Figure 15: Control Panel Select Ethernet communication
8. Following Step 7, if you are still having trouble communicating with the camera then
refer to the please refer to the Ethernet Quick install guide ISC doc. 421-0007-12.

Connecting Micron/A10 to a PC via the Firewire(IEEE-1394) Module

9. Follow the steps shown in Section 0 for basic connection of the Micron/A10 camera and
the Firewire Module.
10. Connect one end of an IEEE-1394 cable to either of the two ports on the Firewire
Module, as shown in Figure 16.
11. Connect the other end of the IEEE-1394 cable to an unused firewire port on your
computer. These ports are usually available on the back of the PC through a standard
firewire PCI card. If using a "firewire ready" laptop, attach the 4-pin to 6-pin converter to
IEEE-1394 cable and attach to laptop as well as the Indigo 9-Volt power supply
connected to the external power input of the Firewire Module, as shown in Figure .
17