Table of Contents
Advertisement
1
FC-Series T Camera Installation
1.9
..
1.9.1
Prior to making any connections, ensure the power supply or circuit breaker is switched off. The
camera itself does not have an on/off switch. Generally the FC-Series T camera will be connected to a
circuit breaker and the circuit breaker will be used to apply or remove power to the camera. If power is
supplied to it, the camera will be powered on and operating.
The power cable supplied by the installer must use wires that are sufficient size gauge for the supply
voltage and length of the cable run, to ensure adequate current carrying capacity (18 AWG
recommended for most installations). Always follow local building/safety codes.
Refer to the diagram below for recommended dimensions for cable jacket and wire stripping.
Note
The terminal blocks for power connections will accept 16 AWG to 20 AWG wire size.
427-0070-11-12, version 100
Camera Connections
Not used
Power
connection
Connecting power
April 2012
Primary video
connection
Alternate video
connection
1-7
Advertisement
Table of Contents
