Control Panel Menu Options - FLIR ThermoVision Micron User Manual

ThermoVision® Micron/A10 User's Guide 412-0006-10 Version 130
Read Camera Temperature. The Read Camera Temperature command updates the
adjacent display window with a measurement of camera case temperature. The temperature
is measured on the camera's metal mounting surface.
Comm. Test. The Comm. Test command is a diagnostic feature for verifying the
communication link between the Control Panel and the Micron/A10 camera. Use this
command if you suspect that the camera and Control Panel are not communicating properly.
The message box in the lower left corner of the Control Panel will state "Communication test
completed" if the interface is working properly. If the message box reports "Camera
Timeout", the link between the camera and Control Panel has been disrupted. Verify that the
camera is still powered and that the serial cable to the PC has not been disconnected. If you
cannot re-establish the Control Panel link, call Indigo Customer Support at (805) 964-9797
for assistance.
Save Current State. After using the Control Panel to change all camera modes and settings
to desired values, use the Save Current State command to store your selections as power-up
defaults. The next time the camera is powered, it will revert to the settings saved as defaults.
Reset. The Reset command causes the camera to revert to its power-up default settings just
as if input power was toggled.
Factory Defaults. The Factory Defaults command restores the camera's modes and settings
to the initial values originally specified by the manufacturer, replacing the customized
selections stored using the Save Current State command.

7.1.5 Control Panel Menu Options

Six menu options are shown across the top of the Micron/A10 Control Panel: File, FFC, Refresh,
Comm, Image and About.
File. The File option is the only true menu, and it includes the single command Quit. The
Quit command closes the Control Panel application.
Note: The Quit command only closes the Control Panel software. It does not power down
the Micron/A10 camera.
FFC. The FFC command executes a manual flat-field-correction, which is described in
more detail in Section 7.1.1.
Refresh. The Refresh command updates the Control Panel to reflect all of the current
settings of the camera. Use Refresh anytime that the Control Panel might not be showing the
30