Programming Features; User Programmable Features - Excalibur RS-350-EDPB Operation Manual

Programming Features

Step 1 Turn the ignition key "ON", then "OFF"
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user
features (10 times to access installer features)�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number�
~ The siren/horn will chirp, the status lights, and the parking lights will flash equal
to the selected feature�
Step 4 Change the feature by pressing the transmitter button that corresponds with
the desired setting� The siren/horn will chirp to correspond with the chosen setting�

user Programmable Features

Feature #1 - SecureCode
DeFaulT - 1 Press
SecureCode is a unique patented feature which allows you to custom select the
number of Valet Switch presses in two stages, instead of a single "1 press", which
would be required in order to perform an Emergency Override. If any of the three anti-
carjacking features are utilized, a customized SecureCode would also be required to
turn it off once it is fully activated� The SecureCode operation is described on page 8�
To custom program a new SecureCode:
Step 1 Follow Steps 1 to 4 in the previous "Programming Features" section to access
"feature #1"�
Step 2 Within 10 seconds slowly press and release the transmitter's "lock" button
the number of times equal to the desired SecureCode for stage 1, allow the system to
respond to each transmitter button press with a siren chirp before pressing the button
again. A few seconds after the final button press, the system will chirp the horn/siren
confirming the total number for stage 1.
Step 3 Configure stage 2 of the SecureCode by pressing and releasing the "unlock"
button the number of times desired for the stage 2� The system will
confirm as it did for stage 1.
Feature #2 - last Door arming
Off
On w/o Doors locking (press "unlock" button to program)
On w/ Doors locking
"Last Door Arming" has the system automatically arm the starter interrupt every time
you exit the vehicle (the complete operation is described on page 7)� This feature
turns that operation on or off, and with options of having Last Door Arming operate
with or without also locking the doors when the starter interrupt does arm�
12
(press "lock" button to program) - DeFaulT
(press "trunk" button to program)