Memory Scan - Icom IC-V85 Instruction Manual

NOTE: Scan edges, 1A–3A/1b–3b, must be programmed
in advance. Program them in the same manner as regular
memory channels. (p. 27)
If identical frequencies are programmed into the scan
edges, programmed scan will not proceed.
PWR
A B C D
FUNC CLR
CALL MR
TONE P.BEEP T.SCAN BANK
1 2 3
DUP OPT
SCAN SKIP
4 0
5 6
PRIO
SET H/M/L
7
8 9 ENT

■ Memory scan

Memory scan repeatedly scans all programmed memory
channels, except those set as skip channels.
q Push [MR] to select memory mode, if necessary.
• " X " appears.
• See below to select bank scan.
w Push [FUNC] and [
• To change the scan direction, push [Y Y ] or [Z Z ].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change
the scan direction. (pgs. 18, 53)
Push
PWR
e Push [CLR] to stop the scan.
• Bank scan —Select the desired bank in step q above.
q Push [FUNC] and [
w Rotate [VOL] to select the desired bank, A to J.
e Push [✱
SCAN OPERATION
](5) to start the scan.
SCAN
A
SCAN
FUNC 5
](#) to select memory bank mode.
BANK
] (or [CLR]) to select the bank.
ENT
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
36