Programming The Memory/Call Channels - Icom IC-V85 Instruction Manual

6
MEMORY/CALL OPERATION

■ Programming the memory/call channels

qPush [CLR] to select VFO mode, if necessary.
w Set the desired frequency.
eSet other information, such as tone, duplex, as desired.
rPush [FUNC], then [MR] momentarily.
• " X " and memory channel number blink.
PWR
A B C D
FUNC CLR
CALL MR
TONE P.BEEP T.SCAN BANK
1 2 3
DUP
SCAN SKIP OPT
4 0
5 6
PRIO
SET H/M/L
7
8 9 ENT
tPush [Y Y ] or [Z Z ] to select the desired memory channel.
• When programming the call channel, select "C."
• When [VOL] is assigned as tuning dial, rotate [VOL] to select
the memory channel. (pgs. 18, 53)
PWR
27
yPush [FUNC], then push and hold [MR] for 1 sec., when 3
beeps will sound to program the information into the se-
lected memory channel and return to VFO.
PWR
A B C D
FUNC CLR
CALL MR
TONE P.BEEP T.SCAN BANK
1 2 3
DUP OPT
SCAN SKIP
4 0
5 6
PRIO
SET H/M/L
7
8 9 ENT
• After 3 beeps are emitted, continue to hold [MR] to increment the
displayed memory channel number.