Icom IC-V85 Instruction Manual page 42

6
MEMORY/CALL OPERATION
D Memory/call ➾ memory/call
qSelect the memory (call) chan-
nel to be transferred:
➥ Push [MR] (or [CALL]) to se-
lect the memory (call chan-
nel) mode.
➥ Push [Y Y ] or [Z Z ] to select the
memory channel.
• When [VOL] is assigned as
tuning dial, rotate [VOL] to se-
lect the memory channel. (pgs.
18, 53)
wPush [FUNC], then push [MR]
momentarily.
• "--" and " X " blink.
ePush [Y Y ] or [Z Z ] to select the target memory.
• When [VOL] is assigned as tuning dial, rotate [VOL] to select
the target channel. (pgs. 18, 53)
r Push [FUNC], then push and hold [MR] for 1 sec.
• Memory mode is selected and the contents are transferred to the
target memory.
29
D Clearing a memory
qPush [CLR] to select VFO mode, if necessary.
wPush [FUNC], then push [MR] to enter the memory trans-
[VOL]
ePush [Y Y ] or [Z Z ] to select the
PWR
A D
B C
FUNC CLR
CALL MR
TONE P.BEEP T.SCAN BANK
1 2
3
DUP
SCAN SKIP OPT
4 0
5 6
PRIO
SET H/M/L
7
8 9 ENT
rPerform the following operation
t Push [CLR] to return to regular operation.
fer mode.
• " X " and a memory channel
number blink.
memory channel to be cleared.
• When [VOL] is assigned as tun-
ing dial, rotate [VOL] to select the
memory channel. (pgs. 18, 53)
• The call channel cannot be
cleared.
within 1 sec, otherwise the
transceiver returns to the mem-
ory mode without clearing the
memory.
- Push [FUNC], then push [MR] momentarily.
- Push [FUNC], then push and hold [MR] for 1 sec.
• The contents of the selected memory are cleared.
PWR
D
A B C
FUNC CALL MR CLR
TONE BANK
P.BEEP T.SCAN
1
2 3
DUP SKIP OPT
SCAN
4 0
5 6
PRIO SET H/M/L
7 8 9 ENT