Separating The Media; Removing The Media - Roland CJ-540 User Manual

2-3 Loading Media

Separating the Media

Make sure the [SETUP] LED lights up.
To cut off a printed portion from the roll, hold down the [SHEET CUT] key for at least one second. The piece is cut off
at the present location of the printing-start line. This step is not necessary when cutoff is performed automatically by
sending a media-cutoff command from the computer.
Depending on the composition of the media, cutoff may
not be possible.
Depending on the composition of the media, media may
remain on the platen after cutoff. If this happens, re-
move it by hand.
When you're performing cutoff, do not use the [
key to pull the media back. Unless the end of the media
has been pulled out to a location to the front of the platen,
cutoff may not be performed smoothly.

Removing the Media

1 Refer to the previous section, "Separating the
Media," and cut off the media.
When the SETUP LED is lighted, hold down
2
the [SETUP] key for at least one second.
3 Move the sheet loading lever toward the back
of the unit.
The pinch rollers rise to release the media.
4 Remove the media.
44
Chapter 2 - Basic Operation
The media is
A
cut off here.
]
Printed portion
The SETUP LED goes out
Sheet loading lever
Knife guide
Present location
of the blade tip