Table of Contents
Advertisement
6
Align the left- and right-hand stoppers with the
width of the media and tighten the screws to
secure in place.
7
Pull out the media so that at least 50 cm (20
in.) hangs down at the front of the machine.
Rotate the media flanges on the shaft to take
8
up the hanging media at the front of the ma-
chine.
To ensure that the media take-up is not crooked,
clear of items such as the media clamps that
may obstruct media feed.
9
With the media pulled out from the roll stretched taut with no slack, move the sheet loading lever
toward "LOAD".
Pinch rollers lower to hold the media in place.
To secure the media in place,
move all the way to "LOAD".
When moved partway, only the
left-hand pinch roller descends.
Data cannot be output while in this
state.
If there is slackness in the loaded media,
the media may move at an angle and come
loose from the pinch rollers.
2-3 Loading Media
Stopper
Screw
Shafts
Continued on the next page
Chapter 2 - Basic Operation
Media flange
39
- Quick Links:
- Features of the Cj-540
Hide quick links:
Advertisement
Table of Contents
