Separating The Media; Removing The Media - Roland SJ-645EX User Manual

Separating the Media

Make sure the [SETUP] LED lights up.
To cut off a printed portion from the roll, hold down the [SHEET CUT] key for at least one second.
The piece is cut off at the present location of the printing-start line. This step is not necessary when cutoff is performed
automatically by sending a media-cutoff command from the computer.
Depending on the composition of the media, cutoff may
not be possible.
Depending on the composition of the media may remain on
the platen after cutoff. If this happens, remove it by hand.
When you're performing cutoff, do not use the [
pull the media back. Unless the end of the media has been
pulled out to a location to the front of the platen, cutoff may
not be performed smoothly.

Removing the Media

Refer to the previous section, "Separating the
1
Media," and cut off the media.
When the SETUP LED is lighted, hold down
2
the [SETUP] key for at least one second.
Move the loading lever toward the back of the
3
unit.
The pinch rollers rise to release the media.
Remove the media.
4
] key to
Printed portion
The SETUP LED goes out
2-2 Loading Media
Knife guide
The media is
cut off here.
Printing-start line
Loading lever
Chapter 2: Basic Operation
43