Separating The Media - Roland TrueVIS VF2-640 User Manual

Setup of Media

Separating the Media

Procedure
1.
Close the front cover.
2.
Check that [SETUP] is lit.
3.
Press [FUNCTION].
4.
Press [▼] several times to display the screen shown below.
FUNCTION
SHEET CUT
5.
Press [ENTER].
When you press [ENTER], the media moves from position
and is separated.
If is obscured by the media clamp, use the two lines (
MEMO
You can configure settings in the software RIP for automatic media separation after output has finished. For information
on how to configure the settings, refer to the documentation for the software RIP you are using.
IMPORTANT
Separation Operations
• When performing separation, do not use [▲] to pull the media back. If the distance from the end of the media to the
separation location is short, separation may not be performed smoothly.
Give Attention to the Media Composition
• For some types of media, separation is not possible.
• Some types of media may remain on the platen after separation. If the media remains on the platen, remove it by
hand.
38
2. Basic Operations
to a position above the separating line (
) on the media clamp as a guide.
)