What To Do If; The Machine Doesn't Run - Roland CJ-540 User Manual

6-1 What to Do If...

The machine doesn't run

The power does not switch on.
Is the main power switched on?
If the power does not come on when you press the [POWER] key, the main power at the back of the machine may not be
switched on. Make sure the main power is switched on, then press the [POWER] key again.
Printing doesn't start when data is sent.
Are the network settings correct?
Make sure there are no errors in the network settings. For more about making the connection to a network, see "Roland
PrintServer Network Settings Guide."
Has media been loaded (the SETUP LED is lit)?
If the SETUP LED is not illuminated, make sure the media is loaded correctly and press the [SETUP] key to illuminate
the SETUP LED.
Is the top menu displayed?
If the top menu isn't displayed, printing doesn't start even
when data is sent from the computer. Press the [ SETUP ]
key, and display the top menu.
Is the PAUSE LED illuminated?
If the [PAUSE] key has been pressed and the PAUSE LED is lighted, the unit has been paused.
To resume printing or cutting, press the [PAUSE] key again. The PAUSE LED is extinguished, and printing or cutting
resumes.
To terminate printing or cutting, first stop the transmission of printing or cutting instructions from the computer to this
machine. Then press the [SETUP] key. Hold down for about 1 second. This deletes the printing or cutting instructions
that have already been sent from the computer to this machine, and printing or cutting is stopped.
Has ink run out?
When printing or cutting data is sent while the screen
shown in the figure is displayed, a message appears and a
warning beep sounds.
At the same time, operation pauses. When the ink car-
tridge is replaced with a new one, printing or cutting starts.
Chapter 6 What to Do If...
102
Top menu
W 1234 mm L ----- mm
1 2 3 4 5 6
7 8 9 10 11 12
This screen show 1 and 7 is run out.