Table of Contents
Advertisement
Connecting secondary interface cables
FAStT600 single-controller storage server (Model 6LU/6LX)
|
|
|
FAStT600 dual-controller storage server (Model 60U/60X)
|
|
|
|
|
|
|
|
Figure 37. Location of host cables (Model 6LU/6LX)
Use the Ethernet interface ports on the back of the storage server to connect the
controllers for direct management of the storage subsystems.
Connect an Ethernet cable from the storage-management station to the Ethernet
port of the controller.
Connect a pair of Ethernet cables from the storage-management station to the
Ethernet ports for Controller A (located on the left) and Controller B (located on the
right) on the back of the storage server. Figure 38 shows the location of the ports.
Controller A
Ethernet port
Figure 38. Ethernet and serial port locations
Important: The serial interface ports are intended to be used by service technicians
to perform diagnostic operations on the storage server. Inappropriate use will result
in loss of system availability, loss of data, or both.
Controller A
Controller B
Serial port
Ethernet port
Chapter 3. Cabling the storage server
Controller B
Serial port
39
Advertisement
Table of Contents
