Table of Contents
Advertisement
|
|
44
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User's Guide
Left ESM board
Out port
In port
Figure 42. Adding a second expansion unit
6. If you are connecting additional expansion units, repeat step 3 through step 5
for each additional drive expansion unit.
7. Remove the blank filler trays and insert drive trays. Connect power to the drive
expansion units first, then connect power to the FAStT600 storage server. After
the storage server is powered-on, the storage server locates the new drives.
8. Use the storage-management software to check the status of the new drives,
correct any errors found, and configure the new drives.
Right ESM board
Out port
New expansion unit
New cables
First expansion unit
Storage server
with two RAID controllers
Advertisement
Table of Contents
