IBM TotalStorage FAStT600 Installation And User Manual page 34

|
|
|
|
|
|
|
|
|
|
10
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User's Guide
Ethernet
Expansion port
Host port 2
Serial port
Host port 1
AC power AC power
connector switch
Figure 5. Model 60U/60X: Interface ports and switches
Figure 6 shows the ports and switches on the back of the FAStT600
single-controller storage server (Model 6LU/6LX).
Figure 6. Model 6LU/6LX: Interface ports and switches
RAID controller
Each RAID controller contains several connectors and LEDs. Each
controller has ports for SFP modules that connect to the Fibre Channel
cables. Two of the ports are for host server attachment. (Each RAID
controller on the FAStT600 Model 60U/60X also has an additional port that
connects FAStT EXP drive expansion units to the storage server.) You first
insert SFPs into the ports and then connect the Fibre Channel cables.
Host ports
The host ports are used to connect a Fibre Channel cable from the host
systems. You first insert an SFP into the port and then connect a Fibre
Channel cable. The two host ports in each controller are independent. They
are not connected in the controller module as they would be in a hub
configuration.
Ethernet
Host port 2
Serial port
Host port 1
Server ID AC power
switch connector
Expansion port
AC power
switch