2.3 Connecting Hardware
This section introduces how to connect EDG-4508(R)+ or EDG-
4516(R)+ to serial devices for first time.
2.3.1 Rack Mounting
2.3.2 Network Connection
Connect the Ethernet cable to EDG-4508(R)+ or EDG-4516(R)+
Ethernet port. There are 2 LED indicator located on front panel to show
the Ethernet status. If the cable is connected correctly, the LAN LED will
indicate a valid connection to the Ethernet in the following ways:
LED
Speed
Link/Active
Note
Speed LED will keep the last status even though the
Ethernet cable is disconnected. While EDG reboot or
re-plug in the Ethernet cable, EDG will detect
Ethernet LAN speed.
Status
Description
Green
100M bps
Off
10M bps
Off
No Ethernet data being received or trans-
mitted
Blinking
Ethernet data being received/transmitted
9
Chapter 2