Matching As/400 Parameters For A 5494 Connected By X.25 - IBM AS/400 Hardware User Manual

Matching AS/400 parameters for a 5494 connected by X.25

You must coordinate communications configuration parameters between the AS/400 and the 5494
controller that is connected by X.25. These parameters are described in the following table. Then the
related fields and subfields from the 5494 configuration display are listed next. These values are followed
by the AS/400 configuration value and the matching 5494 value to be entered in the display subfield. You
can coordinate these values automatically or manually. Pick one of these ways:
v To automatically connect the AS/400 to a 5494 controller, you can use the automatic remote controller
(QAUTORMT) system value.
v To manually connect the AS/400 to a 5494 controller:
– See "Example: Connecting AS/400 to a 5494 controller connected by X.25" on page 56 for an
example of connecting AS/400 to a 5494 controller by X.25.
– Use the following table to connect an AS/400 to a 5494 controller that is connected by X.25.
For more information about configuring the 5494, see these books:
v IBM 5494 Remote Control Unit Planning Guide, GA27-3936
54
Version 5