Matching As/400 Parameters For 3X74 Controller; Matching As/400 Parameters For A 3174 Controller - IBM AS/400 Hardware User Manual

Matching AS/400 parameters for 3x74 controller

You must match the AS/400 configuration parameters with some configuration questions and sequence
numbers when you configure the 3174 and 3274 controllers.
For an example of connecting an AS/400 to a 3174 retail controller, see "Example: Connecting an AS/400
to a 3174 control unit" on page 61.
v "Matching AS/400 parameters for a 3174 controller"
v "Matching AS/400 parameters for a 3274 controller" on page 60

Matching AS/400 parameters for a 3174 controller

You must match the AS/400 configuration parameters with the configuration questions and sequence
numbers to configure the 3174 controller. These parameters are described in the following table.
For more information about configuring the 3174 controllers, see these books:
v 3174 Subsystem Control Unit Customizing Guide
v 3174 Establishment Controller Supplemental Customer Information for Configuration Support C Release
4 Ethernet Attachment, GA27-3994 has information about Ethernet support.
To configure the AS/400 to a 3174 controller:
v See "Example: Connecting an AS/400 to a 3174 control unit" on page 61 for an example of connecting
an AS/400 to a 3174 retail controller.
v Use the following table to connect an AS/400 to a 3174 remote controller.
AS/400 AS/400
Prompt Parameter
LAN remote ADPTADR
adapter
1
address
58
Version 5
3174
Configuration
Questions
084, 106 Ethernet Address
If the AS/400 system uses an Ethernet line to connect to the
3174 controller, use table C-3 on page C-4 in "Appendix C:
Local Area Network Addressing Considerations" of the
Communications Configuration
value specified for question 084. Specify the converted
address for the ADPTADR parameter on the CRTCTLRWS
or CRTCTLAPPC command.
Token-Ring Network Address of the 3174
If the AS/400 system uses a Token-Ring network line to
connect to the 3174 controller, values specified for question
106 and for the ADPTADR parameter on the CRTCTLRWS
or CRTCTLAPPC command must match.
If the AS/400 system uses an Ethernet line through an 8209
LAN Bridge, see "Appendix C: Local Area Network
Addressing Considerations" in the Communications
Configuration book.
Notes
book to convert the